Cesium Phosphate,CAS : 17893-64-0

E FORU specializes in producing high purity Chromium Phosphate Hydrate,CAS : 84359-31-9 with the smallest possible average grain sizes,Purities may include 99%, 99.9%, 99.99%, 99.999% and 99.9999%, which are sometimes referred to as 2N, 3N, 4N, 5N and 6N. 99.99995% (6N5), and in some cases up to 99.99999% (7N) and 99.999999% (8N),E FORU produces to many standard grades when applicable, including Mil Spec (military grade); ACS, Reagent and Technical Grade; Food, Agricultural and Pharmaceutical Grade; Optical Grade, USP and EP/BP (European Pharmacopoeia/British Pharmacopoeia) and follows applicable ASTM testing standards. Typical and custom packaging is available. Our standard powder particle sizes average in the range of - 325 mesh, - 200 mesh,- 100 mesh, 10-50 microns and submicron ( 1 micron). We can also provide in the nanoscale range.Powders are also useful in any application where high surface areas are desired such as water treatment and in fuel cell and solar applications. Nanoparticles also produce very high surface areas.Production of Diammonium phosphate – (NH4)2HPO4,Disodium phosphate – Na2HPO4,Metaphosphate – (PO3)−,Monosodium phosphate – NaH2PO4,Organophosphorus compounds, and numerous others.In organic chemistry, phosphate or orthophosphate is an organophosphate, an ester of orthophosphoric acid of the form PO4RR′R″ where one or more hydrogen atoms are replaced by organic groups. An example is trimethyl phosphate, (CH3)3PO4. The term also refers to the trivalent functional group OP(O−)3 in such esters. Phosphates may contain sulfur in place of one or more oxygen atoms (thiophosphates and organothiophosphates).The phosphate or orthophosphate ion [PO4]3− is derived from phosphoric acid by the removal of three protons H+. Removal of one proton gives the dihydrogen phosphate ion [H2PO4]− while removal of two protons gives the hydrogen phosphate ion [HPO4]48−. These names are also used for salts of those anions, such as ammonium dihydrogen phosphate and trisodium phosphate..Quality inspection department staff which uses atomic spectroscopy, x-ray diffraction analysis, scanning electron microscopy, glow discharge mass spectroscopy (GDMS), and BET surface area analysis, among other technologies, to ensure that the elemental composition and structural properties of each product rigorously adhere to our standards.Additional technical, research and safety (MSDS) information is available,